Products - SUNBLIND^®

The colours

ISOLAR SUNBLIND^® is available in a wide range of coloured slats, some of which are available with wood-finish effects.

Sunblind colours .

NOTE: The colours printed in this catelogue may vary slightly the
actual slats.

The models

ISOLAR SUNBLIND^® SF-A: Electrically adjustable. This type of SUNBLIND^® allows the user to adjust the slats of the blind by means of an electrical system powered by batteries located inside the gap in the frame. The slats can also be adjusted by pressing two buttons, which are also attached to the carpentary frame.

ISOLAR SUNBLIND^® SF-RC: Remote Control Adjustable. ISOLAR SUNBLIND^® SF-RC works in the same way as the SF-A model. The difference is that it is operated by remote control. The electrical system is located in an information receiver attached to the inside surface of the double-glazing. This receiver also contains the battery that feeds the motor used for positioning the slats.

ISOLAR SUNBLIND^® SF-M: Magnetic adjustment. This variety of SUNBLIND^® has the same properties as the previous models, as it is also possible to adjust the slats of the blind. Nevertheless, in this case the system is magnetic rather than electrical. By using two magnets, one inside the gap and the other fixed to the outside face of the lower pane of the glazing, by moving by a chain fixed to the latter, the user can adjust the slats as required.

ISOLAR SUNBLIND^® SF-D: Electrically adjusted and elevated. The SF-D model enables not only adjustment of the slats, but also the ability to lift the slats, leaving the glazing free of any obstacles. ISOLAR SUNBLIND^® SF-D works by using an electrical transformer located outside the glazing, preferably on the wall. This transformer has a switch for operating the different functions of the blind. The whole system is fed by the mains electricity of the building where it is installed.

Table